|
Post by lynnee on Oct 22, 2022 22:17:42 GMT -5
Today I did R&Rs for five wireless Bounties. As usual, the lights kind of blinked on and off when water dripped from the plants' roots onto the display during removal of the grow deck from the bowl. I never thought much about this, but today the "buttons" on one Bounty were unresponsive or sluggish when I tried to hit "Plant Food Added". I think that water must have gotten inside the base at the point where the electronic display is set into the base. The buttons wouldn't let me reset the Plant Food Cycle or the clock, but I was able to reset the clock via the wireless app. Unplugging the Bounty brought up the screen for indicating "My Power Went Out", and then a few more buttons worked, and I was able to reset the Plant Food Cycle. After a couple of hours, I unplugged and replugged the Bounty, and even more buttons worked. It looks like all of the buttons will be working after the Bounty has a little more time to dry out. However, the lesson learned is that one should NOT allow water to drip on the electronic display. In the future, I will cover the base with a towel when I pull the plants out for an R&R!
|
|
|
Post by scarfguy on Oct 23, 2022 6:29:51 GMT -5
I never disturb my grow deck when I do an R&R. I use a high quality siphon. (one used for gasoline, not the stupid little one aerogarden sells). I just siphon all the water out into a bucket and refill with fresh water. This way, I don' have your issue nor do I disturb the roots or let them dry out very long. I don't get ALL of the water out. There is always a little bit left in the bottom of the bowl but I think that is ok.
|
|
|
Post by lynnee on Oct 23, 2022 9:38:38 GMT -5
scarfguy, in the past I used a battery-operated siphon for R&Rs, but they all stopped working without warning after a few months. Which one are you using?
|
|
|
Post by scarfguy on Oct 23, 2022 10:07:09 GMT -5
scarfguy , in the past I used a battery-operated siphon for R&Rs, but they all stopped working without warning after a few months. Which one are you using?
This is a manual squeeze bulb siphon but it has been working well for me.
|
|
campingcorgis
AGA Farmer
🌴 I wet my plants. :-) 🌴
Posts: 3,114
|
Post by campingcorgis on Oct 23, 2022 11:00:54 GMT -5
I've always just removed the entire bowl. Take it to the sink, remove the deck, dump bowl and rinse it out. Then, I prune roots and examine them too. Make sure the pump filter is clean and in place. Then I replace the deck, move it back to the machine and fill it, add nutes, presto, done? The only time I use a pump is for Farms. And that is simply to make it easier to remove the bowl to the since and repeat process above.
|
|
mike
The Pepper King
Posts: 3,661
|
Post by mike on Oct 23, 2022 15:25:23 GMT -5
I use a pump from Amazon. They are cheap, last 3-4 years and work great. I pump the water into a bucket and then take the bowl to dump. My balance issues make it too hard not to slosh dirty water all over the place, otherwise. This is the pump I use:
|
|
|
Post by tompepper7 on Oct 23, 2022 19:38:32 GMT -5
|
|
Shawn
Administrator
Posts: 16,265
|
Post by Shawn on Oct 24, 2022 6:21:03 GMT -5
I totally forgot I have the same one mike
|
|
|
Post by lynnee on Oct 25, 2022 0:16:43 GMT -5
I use a pump from Amazon. They are cheap, last 3-4 years and work great. I pump the water into a bucket and then take the bowl to dump. My balance issues make it too hard not to slosh dirty water all over the place, otherwise. This is the pump I use: mike, that is the pump that keeps quitting on me unexpectedly. It happens even when I'm careful not to get water into the battery compartment. Three of them failed. I wonder whether the ones they are selling now have quality control issues?
|
|